Cisco Basic VLAN Management

Below i present some basic Cisco IoS VLAN command to help manage basic VLAN configuration.

To remove any VLAN do the following.

(Depending on configuration you may need to do it on aggregate switches)

Once connected to your iOS

1. Removal of vlan

enable

show vlan (take id for removal)

configure terminal (conf t)

no vlan 999 (your id)

end

wr (copy running-config startup-config

2. To rename any VLAN

enable

show vlan (take id)

conf t

vlan 999 (your id)

name myNewName

end

wr

exit

These two basis procedure¬†will allow you to remove your vlan or basically change it’s name if needed.

Advertisements

How to convert disk to QPT from MBR to allow Windows 8 instalation

Once in Setup navigate to troubleshoot then Command line then use the following:

NOTE: THIS WILL ERASE DATA ON HARD DRIVE SO USE WITH CAUTION.

diskpart

list disk

select disk (number) eg. 1

clean

convert qpt

exit

then setup to start windows installation process again.